Differences

This shows you the differences between two versions of the page.

--- nberrorcodes [2020/11/10 21:48] – fixed a table formating error foxmaster
+++ nberrorcodes [2021/05/20 04:27] – lothean
@@ Line 19: / Line 19: @@
 |25|Communication failure during ESC fimware update|Hard-reset scooter|System error|3|
 |26|Flash save error|Try to flash ESC with ST-Link ([[https://www.scooterhacking.org/forum/viewtopic.php?f=6&t=40|ESx]], [[https://www.scooterhacking.org/forum/viewtopic.php?f=26&t=213|Max]]), replace ESC|System error|3|
-|27|ESC config invalid|Try to flash ESC with ST-Link ([[https://www.scooterhacking.org/forum/viewtopic.php?f=6&t=40|ESx]], [[https://www.scooterhacking.org/forum/viewtopic.php?f=26&t=213|Max]]) / change SN ([[https://bit.ly/ESx-Activation|ESx]], [[https://bit.ly/max-unlock|Max]])|System warning|1|
+|27|ESC config invalid (CPUID register might not match STM CPUID)|Change SN using BLE/UART ([[https://bit.ly/ESx-Activation|ESx]], [[https://bit.ly/max-unlock|Max]])|System warning|1|
 |28|Motor driver mos up-bridge short circuit|Check motor|Hardware error|3|
 |29|Motor driver mos down-bridge short circuit|Check motor|Hardware error|3|
@@ Line 29: / Line 29: @@
 |38|Charging overcurrent|Incorrect power supply|Hardware error|3|
 |39|Internal battery overheat| |Hardware error/battery mod warning|2|
-|40|ESC overheat| |Hardware error|3|
+|40|ESC overheat|Let the scooter cool down / check temperature sensors|Hardware error|3|
 |41|External battery overheat| |Hardware error|3|
 |42|No communication with external BMS|Inspect external battery connectors, tighten up external battery screws|Hardware error|3|