nberrorcodes
This is an old revision of the document!
Ninebot ESx/Max Error Codes
Code | Description | Additional information |
---|---|---|
10 | No communication with BLE board | Check the connection between dashboard and ESC, try to flash ESC with ST-Link (ESx) |
11 | Motor phase A current out of range | |
12 | Motor phase B current out of range | |
13 | Motor phase C current out of range | |
14 | Throttle handle position out of range | Throttle might be stuck, faulty or disconnected |
15 | Brake handle position out of range | Brake handle might be stuck, faulty or disconnected |
18 | Motor Hall sensors stuck at 0/1 | Check 2×4 connector between ESC and motor; attempt fix |
19 | Internal battery voltage out of range | |
20 | External battery voltage out of range | |
21 | No communication with internal BMS | Check data connector between internal battery and ESC, replace battery |
22 | Internal BMS config invalid | Replace internal BMS or battery; attempt a fix |
23 | Internal BMS not activated (has default S/N) | Replace internal BMS or battery; attempt a fix |
24 | Supply voltage out of range | |
26 | Flash save error | Try to flash ESC with ST-Link (ESx), replace ESC |
27 | ESC config invalid | Try to flash ESC with ST-Link (ESx) |
32 | No communication with IoT device | Leave that rental scooter where it belongs |
35 | ESC not activated, has default S/N | for ESx, for Max |
36 | 2+4 connector failure or external battery charging wire failure. | |
37 | Charging base failure or built-in battery charging wire failure. | |
38 | Charging overcurrent | Incorrect power supply |
39 | Internal battery overheat | |
40 | ESC overheat | |
41 | External battery overheat | |
42 | No communication with external BMS | Inspect external battery connectors, tighten up external battery screws |
43 | External BMS config invalid | Replace external BMS or battery; attempt a fix |
44 | External BMS not activated (has default S/N) | Replace external BMS or battery; attempt a fix |
45 | Internal BMS deep cell discharge | |
46 | External BMS deep cell discharge | |
49 | Internal BMS firmware version mismatch | Change internal BMS firmware version |
50 | External BMS firmware version mismatch | Change external BMS firmware version |
nberrorcodes.1572207552.txt.gz · Last modified: 2022/01/15 01:34 (external edit)