diy-coulombmeter
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| diy-coulombmeter [2021/04/26 09:17] – hopefully done for now tidings | diy-coulombmeter [2022/01/15 01:36] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 24: | Line 24: | ||
| Cut a 45x16mm rectangle hole into the front lid (using a dremel cutter and chisel for example), then slide in the assembly until it clicks together. | Cut a 45x16mm rectangle hole into the front lid (using a dremel cutter and chisel for example), then slide in the assembly until it clicks together. | ||
| - | {{https:// | + | {{https:// |
| Drill approx. 6mm holes into the bottom part sides, one on each side, pull the wires through, then use flowable silicone to seal them. Finally, add a vinyl or tape protective film to avoid moisture from entering the inside. | Drill approx. 6mm holes into the bottom part sides, one on each side, pull the wires through, then use flowable silicone to seal them. Finally, add a vinyl or tape protective film to avoid moisture from entering the inside. | ||
| Line 38: | Line 38: | ||
| Finally, once you acquire values, to reset them, hold down the button on main screen, then doubletap to switch between parameters, and finally single tap to reset. Hold button to get out of this edit mode. | Finally, once you acquire values, to reset them, hold down the button on main screen, then doubletap to switch between parameters, and finally single tap to reset. Hold button to get out of this edit mode. | ||
| - | {{https:// | + | {{https:// |
| ===== Conclusion ===== | ===== Conclusion ===== | ||
diy-coulombmeter.1619428651.txt.gz · Last modified: 2022/01/15 01:34 (external edit)